Removal and Installation

NOTE: For information on Ford Color Coded Illustrations refer to COLOR-CODING - FORD .

All vehicles

NOTE: To prevent setting DTCs, make sure the ignition switch is in the OFF position prior to disconnecting the accelerator pedal electrical connectors.

NOTE: If equipped, the red clip must be pulled out before disconnecting the electrical connector.

Disconnect the Accelerator Pedal Position (APP) sensor electrical connector.

4.6L and 5.4L engines
Remove the 2 bolts and the accelerator pedal.
- To install, tighten to 25 Nm (18 lb-ft).
6.8L engine
Remove the 2 bolts and slide the accelerator pedal and position sensor assembly up and off the anchor bolt.
- To install, tighten to 25 Nm (18 lb-ft).
All vehicles
To install, reverse the removal procedure.