Body Control Module (BCM)

DTC INDEX

DTC	Description	Action
BCM DTCs	BCM DTCs not listed in this chart.	REFER to MULTIFUNCTION ELECTRONIC MODULES .
B10D5:13	PATS Antenna: Circuit Open	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D7:05	PATS Key: System Programming Failure	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D7:51	PATS Key: Not Programmed	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D7:55	PATS Key: Not Configured	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D7:87	PATS Key: Missing Message	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D7:8F	PATS Key: Erratic	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D8:00	PATS Key Less Than Minimum Programmed: No Sub Type Information	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10D9:87	PATS Transponder: Missing Message	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10DA:51	PATS Target Identifier: Not Programmed	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
C113A:11	Wakeup Control: Circuit Short to Ground	GO to PINPOINT TEST D .
C113A:15	Wakeup Control: Circuit Short to Battery or Open	GO to PINPOINT TEST D .
U1000:00	Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information	The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test.