Section 1 (OEM Connector Repair Procedures -- Electric)
WARNING: This page is about a different variant/trim than selected.
- Connector Repair Procedures
- Troubleshooting Wiring Harness And Connector Hidden Concerns
- Non Safety Restraint System Repairs
- Important Notice Regarding Safety Restraint Systems:
- Terminal Not Properly Seated
- Defective Insulation Stripping
- Partially Mated Connectors
- Deformed (Enlarged) Female Terminals
- Electrical Short Inside The Harness
- Electrical Short Within The Harness
- Broken Wire Strands In Harness
- Recommended Splicing Method - Solder (For 16 Awg/1.0Mm And Smaller Diameter Wire Only)
- Recommended Splicing Method - Crimp (For 10-22 Awg (0.35-5.0Mm) Diameter Wire To Like Wire Diameter)