| U0155:00 |
Lost Communication With IPC Module: No Sub Type Information |
GO to PINPOINT TEST Y
. |
| U0184:00 |
Lost Communication With Radio: No Sub Type Information |
GO to PINPOINT TEST Z
. |
| U0253:00 |
Lost Communication With Accessory Protocol Interface Module: No Sub Type Information |
GO to PINPOINT TEST AA
. |
| U0256:00 |
Lost Communication With Front Controls Interface Module: No Sub Type Information |
GO to PINPOINT TEST AB
. |
| U201A:51 |
Control Module Main Calibration Data: Not Programmed |
- This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM.
- If there have been recent service actions with the FCDIM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to Programmable Module Installation (PMI) in
MODULE CONFIGURATION
.
- If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM)
.
|
| U2100:00 |
Initial Configuration Not Complete: No Sub Type Information |
- This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM.
- If there have been recent service actions with the FCDIM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to Programmable Module Installation (PMI) in
MODULE CONFIGURATION
.
- If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM)
.
|
| U2101:00 |
Control Module Configuration Incompatible: No Sub Type Information |
- This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM.
- If there have been recent service actions with the FCDIM, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. REFER to Programmable Module Installation (PMI) in
MODULE CONFIGURATION
.
- If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM)
.
|
| U3000:41 |
Control Module: General Checksum Failure |
CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:41 is still present, INSTALL a new FCDIM. Refer to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM)
. |
| U3000:42 |
Control Module: General Memory Failure |
CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:42 is still present, INSTALL a new FCDIM. Refer to FRONT CONTROLS/DISPLAY INTERFACE MODULE (FCDIM)
. |
| U3003:16 |
Battery Voltage: Circuit Voltage Below Threshold |
GO to PINPOINT TEST AD
. |
| U3003:17 |
Battery Voltage: Circuit Voltage Above Threshold |
GO to PINPOINT TEST AE
. |