| P0512 |
Starter Request Circuit |
CARRY OUT the Ignition Switch component test. Refer to Component Testing
. If necessary, INSTALL a new ignition switch. REFER to
Steering Column Switches
. If the ignition switch passed the component test, REPAIR circuit CDC35 (BU/WH) for a short to voltage. |
| P06E9 |
Engine Starter Performance |
If the engine cranks, REFER to Engine Controls - Introduction (Except Diesel & Hybrid)
. If the engine does not crank, for vehicles without push button start, GO to Pinpoint Test A . For vehicles with push button start, GO to Pinpoint Test B . |
| P0706 |
Transmission Range Sensor "A" Circuit Range/Performance |
REFER to
Automatic Transmission 6F50/6F55
or REFER to
Automatic Transmission 6F35
. |
| P0708 |
Transmission Range Sensor "A" Circuit High |
REFER to
Automatic Transmission 6F50/6F55
or REFER to
Automatic Transmission 6F35
. |
| P1594 |
Forced Engine Shutdown - Remote Start System Fault, No Unattended Vehicle Timeout |
GO to Pinpoint Test H . |
| P1595 |
Forced Engine Shutdown - Remote Start System Fault, Transmission Range Not In Park Position |
GO to Pinpoint Test I . |
| P161A |
Incorrect Response From Immobilizer Control Module |
REFER to
Anti-Theft Passive Anti-Theft System (PATS) Without Intelligent Access
or REFER to
Anti-Theft Passive Anti-Theft System (PATS) With Intelligent Access
. |
| P1702 |
Transmission Range Sensor Circuit Intermittent |
REFER to
Automatic Transmission 6F50/6F55
or REFER to
Automatic Transmission 6F35
. |
| P1705 |
Transmission Range Circuit Not Indicating Park/Neutral During Self Test |
REFER to
Automatic Transmission 6F50/6F55
or REFER to
Automatic Transmission 6F35
. |
| P2535 |
Ignition Switch Run/Start Position Circuit High |
GO to Pinpoint Test G . |
| All Other DTCs |
- |
REFER to
Electronic Engine Controls
. |