Powertrain Control Module (PCM): Installation

1.

Install the PCM and connect the PCM electrical connectors.

GFD49852

Courtesy of FORD MOTOR COMPANY

2.

Position the PCM and attach the wiring retainer, install the retainers.

GFD49851

Courtesy of FORD MOTOR COMPANY

3.

Install the retainers and the PCM cover.
Torque:

27 lb.in (3 Nm)

GFD49850

Courtesy of FORD MOTOR COMPANY

4.

Install the LHF fender splash shield. REFER to: Fender Splash Shield

5.

NOTE: This step is only necessary when installing a new component.

Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. REFER to: Module Configuration - System Operation and Component Description Use the General Equipment: Ford Diagnostic Equipment

6.
- Reprogram the PATS. Carry out the Parameter Reset procedure. For vehicles without Intelligent Access (IA). REFER to: Passive Anti-Theft System (PATS) Parameter Reset
- Reprogram the PATS. Carry out the Parameter Reset procedure. For vehicles with Intelligent Access (IA). REFER to: Passive Anti-Theft System (PATS) Parameter Reset

7.

After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure.