FixVault
Home › Ford › 2016 › F-150 Limited, 4WD › Repair and Diagnosis (Single Page) › Accessories & Equipment › Warning Systems › Side And Rear Vision System › Removal And Installation › Side Obstacle Detection Control Module › Removal

Side Obstacle Detection Control Module: Removal

  1. 1.

    NOTE: If installing a new SODL or SODR, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new SODL or SODR after installation.

    Using a diagnostic scan tool, begin the PMI process for the SODL or SODR following the onscreen instructions.

  1. 2.

    Remove the rear lamp assembly. Refer to: Rear Lamp Assembly .

  1. 3.

    Remove the screws and position the SODL or SODR cover aside.
GFD42497Courtesy of FORD MOTOR COMPANY

  1. 4.

    Remove the SODL or SODR.

    1. 1.

      Disconnect the electrical connector.

    1. 2.

      Remove the screws.
GFD42498Courtesy of FORD MOTOR COMPANY
About FixVault