FixVault
Home › Ford › 2017 › Explorer Platinum › Repair and Diagnosis › External Pages › Different car › Section 1 (Body Closures) › General Procedures › Power Liftgate Initialization

Power Liftgate Initialization

WARNING: This page is about a different car, the 2017 Ford Police Interceptor Utility. However, it is still accessible from the selected car via links, so may be relevant.

Initialization 

  1. 1.

    Disconnect the battery or remove the RGTM fuse(s). REFER to: Battery Disconnect and Connect .

  1. 2.

    NOTE: Remove the battery power from the RGTM for 20 seconds before entering initialization mode.

    Wait 20 seconds and reconnect the battery or reinstall the RGTM fuse(s). REFER to: Battery Disconnect and Connect .

  1. 3.

    If the liftgate is not already in the fully closed position, manually close and fully latch the power liftgate.

  1. 4.

    NOTE: If equipped, make sure the power liftgate system is turned ON in the message center before performing this step.
    NOTE: If the power liftgate does not open during this step, refer to the Symptom Chart  to diagnose the inoperative power liftgate.

    Power open the liftgate by using a programmed RKE transmitter or the front control switch.

  1. 5.

    Once the liftgate is fully open, power close the liftgate by using a programmed RKE transmitter or the front power liftgate control switch.

  1. 6.

    Carry-out the RGTM self-test.
About FixVault