FixVault
Home › Ford › 2017 › Mustang EcoBoost, Automatic Trans › Repair and Diagnosis › Accessories & Equipment › Communication Devices › MULTIFUNCTION Electronic Modules › Removal And Installation › Body Control Module (BCM) › Installation

Body Control Module (BCM): Installation

  1. 1.

    NOTE: If installing a new BCM, the ignition cannot be turned on until a parameter reset is performed and 2 keys are programmed to the vehicle. The BCM still communicates with the diagnostic scan tool with the ignition off. Use the previous diagnostic scan tool session or start a diagnostic scan tool session using the PCM part number or tear tag number located on the PCM.

    To install, reverse the removal procedure.

NOTE: Carry out the remaining steps only if installing a new BCM.

  1. 2.

    NOTE: A diagnostic scan tool should not  be used to program keys for this specific step.

    Program the keys.

    • Press the START/STOP button and wait approximately 6 seconds.
    • Press the START/STOP button and remove the first key.
    • Place the second key in the backup starting location.
    • Press the START/STOP button.

  1. 3.

    Carry out the parameter reset. Refer to: Anti-Theft Security Access and Key Programming - Scan Tool .

  1. 4.

    Using a diagnostic scan tool, complete the PMI process for the BCM following the on-screen instructions.

  1. 5.

    Using a diagnostic scan tool, carry out the Configuration Engine Immobilizer (CEI) configuration following the on-screen instructions (Toolbox > Body > Service Functions > CEI Lock Configuration).

  1. 6.

    Using a diagnostic scan tool, carry out the battery monitor sensor reset following the on-screen instructions (Toolbox > Body > BMS Reset).

  1. 7.

    If equipped with video rear parking aid, using a diagnostic scan tool, carry out the new module initialization following the on-screen instructions (Toolbox > Electrical > Service Functions > LIN New Module Initialization).

  1. 8.

    NOTE: This step is only necessary if equipped with Electronic Steering Column Lock (ESCL).

    Carry out the BCM to Electronic Steering Column Lock (ESCL) configuration/training procedure. Refer to: Anti-Theft Security Access and Key Programming - Scan Tool .

  1. 9.

    Configure the customer preference programmable parameters. Refer to: Module Configuration - System Operation and Component Description .

  1. 10.

    Train the tire pressure sensors. Refer to: Tire Pressure Monitoring System (TPMS) Sensor Location Calibration .

  1. 11.

    Carry out the BCM self-test (must include an on-demand self-test) and then repeat the self-test to confirm all Diagnostic Trouble Codes (DTCs) have been cleared.

  1. 12.

    Using a diagnostic scan tool, complete the PMI process for the PAM following the on-screen instructions.
About FixVault