Pinpoint Test Am Central Configuration Fault

AM1 : RETRIEVE RCM DTCS

NOTE: Diagnose all network-related (lost communication) DTCs first.

Ignition ON, engine OFF.
Carry out the RCM self-test.
Is DTC U2300:55 or U2300:64 retrieved as an on-demand (not continuous) DTC during the self-test?

Yes	No
If DTC U2300:55 or U2300:64 is retrieved on-demand, Go to AM2.	If DTC U2300:55 or U2300:64 is retrieved as a CMDTC, CLEAR the RCM DTCs and REPEAT the self-test. If DTC U2300:55 or U2300:64 does not return. No fault found. RELEASE the vehicle to the customer. If DTC U2300:55 or U2300:64 returns on-demand, Go to AM2. For all others, No fault found.

AM2 : CHECK FOR THE CORRECT BCM

Using the Log Viewer function of the diagnostic scan tool, retrieve and record the BCM part number.
Check the recorded part number against the number listed in the Ford parts catalog.
Does the recorded part number match the number listed in the Ford parts catalog?

Yes	No
Go to AM3.	INSTALL the correct BCM and USE As-Built data when carrying out PMI. REFER to the appropriate Removal and Installation procedure in appropriate Multifunction Electronic Modules article. Go to AM4.

AM3 : CHECK FOR THE CORRECT RCM

Using the Log Viewer function of the diagnostic scan tool, retrieve and record the RCM part number.
Check the recorded part number against the number listed in the Ford parts catalog.
Does the recorded part number match the number listed in the Ford parts catalog?

Yes	No
CARRY OUT PMI for the BCM using As-Built data. CLEAR the DTCs and REPEAT the RCM self-test. If DTC U2300:55 or U2300:64 are retrieved, CARRY OUT PMI for the RCM using As-Built data. Go to AM4.	INSTALL the correct RCM and use As-Built data when carrying out PMI. REFER to the appropriate Removal and Installation procedure in the appropriate article. Go to AM4.

AM4 : CHECK FOR ADDITIONAL RCM OR BCM DTCS

NOTE: Make sure all SRS components and the RCM electrical connectors are connected before carrying out the self-test. If not, DTCs are set.

Yes	No
If RCM DTCs were retrieved, do no clear any DTCs until all DTCs have been resolved. REFER to the RCM DTC Chart . If BCM DTCs were retrieved, DIAGNOSE the BCM. REEFER to appropriate Multifunction Electronic Modules article	Clear all CMDTCs. PROVE OUT the SRS. The repair is complete. RETURN the vehicle to the customer.