FixVault
Home › Ford › 2018 › Explorer Platinum › Repair and Diagnosis › External Pages › Different car › Section 13 (Electronic Engine Controls System - 3.0L ECOBOOST) › Removal And Installation › Powertrain Control Module (PCM) › Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2018 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. NOTE: This step is only necessary when installing a new component.

    Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Programming . Use the General Equipment: Ford Diagnostic Equipment.

  3. NOTE: This step is only necessary when installing a new component.

    Reprogram the Passive Anti-Theft System (PATS). Refer to: Anti-Theft Key Programming - Scan Tool .

  4. NOTE: This step is only necessary when installing a new component.

    Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.

About FixVault