FixVault
Home › Ford › 2019 › Flex SE › Repair and Diagnosis › External Pages › Different car › Section 247 (MULTIFUNCTION Electronic Modules) › Removal And Installation › Body Control Module (BCM) › Installation

Body Control Module (BCM): Installation

WARNING: This page is about a different car, the 2018 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. Install the BCM and connect the electrical connectors.
  2. NOTE: If the BCM was not replaced, this is the last step that is necessary.

    Install the steering column opening trim panel.

  3. NOTE: If the ignition is left in RUN or ACC and the engine is OFF during the vehicle battery charging process, the Battery Monitoring System(BMS) can turn off the ignition causing the configuration to fail.

    After battery charging is complete, carry out the BMS reset by following the scan tool on screen instructions.

    Vehicles with IA 

  4. If installing a new BCM, carry out the parameter reset procedure. Refer to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET .
  5. Carry out the keyless entry keypad code reset. Refer to Keyless Entry Keypad Code Programming .
  6. Follow the scan tool on-screen instructions for performing the Configurable Engine Immobilizer (CEI) lock configuration.

    Vehicles without IA 

  7. If installing a new BCM, carry out the parameter reset procedure and program the keys. Refer to GENERAL PROCEDURES .

    All vehicles 

  8. Train the tire pressure sensors. Refer to Tire Pressure Monitoring System (TPMS) .
  9. NOTE: If the dome lamps are flashing after BCM installation, it was not configured completely. Repeat steps 3 through 7.

    Carry out the BCM self-test to confirm all DTCs have been cleared.

About FixVault