Pinpoint Test T: Brake System Fill Not Complete
- Normal Operation and Fault Conditions
These Diagnostic Trouble Codes (DTCs) are pre-set in a new ABS module and can only be cleared when the brake system has been successfully bled.
The brake system requires a certain amount of hydraulic fluid for correct operation. When the brake system is filled, the ABS module sets a PID. If the vehicle is operated and the ABS module detects this PID has not been set, a DTC is set.
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition ABS C1020:00 Brake System Fill Not Complete: No Sub Type Information This DTC is pre-set in a new ABS module and can only be cleared when the brake system has been successfully bled. ABS C1020:52 Brake System Fill Not Complete: Not Activated This DTC is pre-set in a new ABS module and can only be cleared when the brake system has been successfully bled. Possible Sources
- Brake system has not been bled
- T1 CHECK THE ABS (ANTI-LOCK BRAKE SYSTEM)DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition ON.
- Using a diagnostic scan tool, carry out the ABS module self-test.
Is any DTC from the DTC Fault Trigger Conditions table present?
Yes CARRY OUT the brake system bleed procedure. REFER to: Brake System Pressure Bleeding - Vehicles With: Electric Brake Booster . or REFER to: Brake System Pressure Bleeding - Vehicles With: Vacuum Brake Booster No The system is operating correctly at this time.