FixVault
Home › Ford › 2023 › Escape ST-Line Select › Repair and Diagnosis › External Pages › Different car › Section 1122 (Electronic Engine Controls - 3.0L ECOBOOST) › Removal And Installation › Powertrain Control Module (PCM) › Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2022 Ford Police Interceptor Utility and 2022 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. NOTE: This step is only necessary when installing a new component.

    Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to Module Programming .

  3. NOTE: This step is only necessary when installing a new component.

    Carry out the Parameter Reset procedure. Refer to Anti-Theft Key Programming - Scan Tool .

  4. NOTE: This step is only necessary when installing a new component.

    Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.

  5. NOTE: This step is only necessary if the PMI routine was completed using as-built data.

    Using the scan tool, Perform the Transmission Strategy Download. Refer to Transmission Strategy Download .

About FixVault