Section 7 (Anti-Lock Brake System): Diagnosis: Notes

WARNING: This page is about a different car, the 1997 Oldsmobile Bravada, 1997 GMC Sonoma, 1997 GMC Jimmy, 1997 Chevrolet S10 Pickup, and 1997 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When testing and diagnosing 4WAL system, use of Tech 1 scan tool is required.

The Vehicle Control Module (VCM) contains a self-diagnostic capability to detect system failures. When a DTC is set, the VCM may disable 4WAL system and illuminate ANTI-LOCK light for duration of ignition cycle. DTCs stored by VCM can be displayed using Tech 1 and appropriate cartridge.

Before diagnosing 4WAL system, perform a comprehensive visual inspection of system by checking wiring harness connectors, harness routing (pay particular attention to wheel speed sensor wiring harness routing), applicable fuses in fuse block, and ground connections. Ensure brake fluid level in master cylinder reservoir is full.

Start 4WAL system diagnosis using DIAGNOSTIC SYSTEM CHECK . If failures are found when performing diagnostic system check, you will be directed to enter diagnostics to retrieve DTCs or perform SYMPTOM TESTS. DIAGNOSTIC SYSTEM CHECK may indicate that system is functioning properly.