FixVault
Home › GMC › 1999 › Yukon Denali › Repair and Diagnosis › External Pages › Different car › Section 13 (Body Control Modules - Old Style) › Removal & Installation › Body Control Module (BCM) › Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2000 GMC Yukon, 2000 Chevrolet Tahoe, 2000 Chevrolet Pickup, and 2000 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Remove seat pedestal trim covers on one front seat. Remove seat-to-floor retaining bolts. Disconnect electrical connector(s) as necessary. Remove seat from vehicle. Remove console trim plate retaining screws. Lift upward on rear of console trim plate and slide rearward. Disconnect electrical connectors as necessary. Remove console trim plate.
  2. Remove 4 console-to-floor retaining bolts. Disconnect instrument panel harness and cross-body harness connectors from console. Slide console rearward and remove from vehicle. Remove amplifier mounting screws. Disconnect amplifier electrical connector. Remove amplifier through bottom of console. Release retaining tabs on BCM. Remove BCM. To install, slide BCM into console and snap tabs into place. To complete installation, reverse removal procedure.
About FixVault