Removal & Installation
- If equipped, disable S.I.R. system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Remove tilt lever (if equipped). Remove 2 lower shroud screws. Tilt lower shroud down and slide back to disengage locking tabs, then remove lower shroud.
- Remove the 2 TORX® screws from the upper steering column shroud. Lift the upper steering column shroud to gain access to the lock cylinder access hole.
- Hold key in START position. Using 1/16" allen wrench or bent tip awl, push on lock cylinder retaining pin. Release key to RUN position, and pull lock cylinder set from lock module assembly.
- To install, insert key into lock cylinder and turn to RUN position. Ensure sector in lock module is in RUN position. Insert lock cylinder into upper cover. Align locking and positioning tabs with slots in lock module assembly, and press lock cylinder into position. To complete installation, reverse removal procedure.