FixVault
Home › GMC › 2001 › Yukon Base, 5.3 T, RWD › Repair and Diagnosis (Single Page) › Accessories & Equipment › Headlights › Lighting Systems › Repair Instructions › Lamp Control Module Replacement › Removal Procedure

Removal Procedure

  1. Remove the IP trim bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement in Instrument Panel, Gauges and Console.
    2. Fig 1: View Of Air Deflector Louver, Retainers & Switches
    GM676695Courtesy of GENERAL MOTORS COMPANY
  2. Remove the head lamp switch/4WD shift button housing from the IP by pulling outwards.

    The arrows in the graphic shows the locations of the retaining clips.

  3. Disconnect all the electrical connectors.
    4. Fig 2: Lamp Module Connector
    GM828425Courtesy of GENERAL MOTORS COMPANY
  4. Remove the electrical tape around the lamp module and discard.
  5. Remove the lamp module from the connector by pulling outwards.
About FixVault