FixVault
Home › GMC › 2002 › Jimmy 2D Utility, Part Time, Automatic › Repair and Diagnosis › External Pages › Different car › Section 1656 (Battery, Charging System And Starting System) › Repair Instructions › Battery Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the battery.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the battery hold down retainer (1), nut (3), and washer.

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

    Fig 1: View Of Battery Hold Down Nut, Retainer & Washer
    GM755443Courtesy of GENERAL MOTORS CORP.
  3. Install the battery cover.
    Fig 2: View Of Battery Cover
    GM755437Courtesy of GENERAL MOTORS CORP.
  4. Install the battery tray brace bolts/nut.

    Tighten:  Tighten the bolts/nut to 10 N.m (89 lb in).

    Fig 3: Radiator Support Diagonal Brace
    GM750114Courtesy of GENERAL MOTORS CORP.
  5. Install the battery air duct to the battery cover.
    Fig 4: View Of Battery Air Duct
    GM899620Courtesy of GENERAL MOTORS CORP.
  6. Install the coolant heater cord retainers (1) to the battery cover, if equipped.
    Fig 5: View Of Coolant Heater Cord Retainers
    GM898846Courtesy of GENERAL MOTORS CORP.
  7. Position the positive battery cable (4) to the battery.
    Fig 6: Identifying Battery cable Components
    GM899613Courtesy of GENERAL MOTORS CORP.
  8. Tighten the positive battery cable bolt.

    Tighten:  Tighten the bolt to 15 N.m (11 lb ft).

  9. Connect the negative battery cable (5). Refer to Battery Negative Cable Disconnect/Connect Procedure .
About FixVault