Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Socket Wrench, Box End Wrench And Pulley

Courtesy of GENERAL MOTORS CORP.

Install the pulley (3) to the generator.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nut using a box end wrench (2) and a socket wrench (1). Tighten the nut with the box end wrench while holding the rotor shaft with the socket wrench.
Tighten: Tighten the pulley nut to 111 N.m (81 lb ft).
Install the generator to the vehicle. Refer to Generator Replacement .