Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electrical Connectors For Blower Motor Control Processor

Courtesy of GENERAL MOTORS CORP.

Install the blower motor control processor (1).

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the blower motor control processor mounting screws (2).
Tighten: Tighten the screws to 1.9 N.m (17 lb in).
Connect the electrical connector (3) to the blower motor control processor (1).
Connect the electrical connector to the blower motor.
Install the right closeout panel. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHT in Instrument Panel, Gages, and Console.