FixVault
Home › GMC › 2002 › Jimmy 4D Utility, AWD › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Power Steering Pump Flow Control Valve Replacement - Off Vehicle (P Series) › Assembly Procedure

Assembly Procedure

  1. Install the flow control spring (2) to the pump housing assembly (1).
  2. Install the control valve assembly (3) to the flow control spring (2).
    Fig 1: Installing Flow Control Spring & Control Valve Assembly (P Series)
    G01669859Courtesy of GENERAL MOTORS CORP.
  3. Install the O-ring seal (3) to the connector and fitting assembly (4).
    NOTE: Refer to FASTENER NOTICE .
  4. Install the connector and fitting assembly (4) to the pump housing (1).

    Tighten 

    Tighten the connector and fitting assembly (4) to 75 N.m (55 lb ft).

    Fig 2: Installing O-Ring Seal & Connector/Fitting Assembly (P Series)
    G01669860Courtesy of GENERAL MOTORS CORP.
About FixVault