FixVault
Home › GMC › 2004 › Canyon 2D Pickup, 3.5 6, RWD, Standard › Repair and Diagnosis › Engine Performance › System › Engine Control System - 3.5L (Introduction) › Repair Instructions › Camshaft Position (CMP) Sensor Replacement-Intake › Installation Procedure

Installation Procedure

  1. Lightly lubricate the O-ring seal with clean engine oil.
  2. Install the intake CMP sensor into the cylinder head.
  3. Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the CMP sensor bolt threads.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the intake CMP sensor bolt.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

    5. Fig 1: View Of Intake CMP Sensor
    GM858173Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness electrical connector to the intake CMP sensor.
    6. Fig 2: View Of Intake CMP Sensor Electrical Connector
    GM1350719Courtesy of GENERAL MOTORS CORP.
About FixVault