FixVault
Home › GMC › 2004 › Jimmy 2D Utility, Part Time, Automatic › Repair and Diagnosis › Body & Frame › Seats › Seat System › Repair Instructions › Seat Back Release Cable Replacement - Front › Installation Procedure

Installation Procedure

    Fig 1: Locating Seat Adjuster Cable Components
    GM822763Courtesy of GENERAL MOTORS CORP.
  1. Install the cable (3) through the hole (2) in the seat adjuster rail.
  2. Hook the cable (3) into the rail and clip the cable to the rail (1).
    3. Fig 2: View Of Seat Adjuster Rail
    GM822760Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the seat adjuster rail to the seat frame with 2 nuts (1).

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft)

    4. Fig 3: Locating Cable Connection Components
    GM822769Courtesy of GENERAL MOTORS CORP.
  4. Install the cable (3) to the seat back pivot assembly.
  5. Install the cable (3) to the pivot assembly bracket by tightening cable nut (2).
    6. Fig 4: Locating Cable Cover Bracket Components
    GM822764Courtesy of GENERAL MOTORS CORP.
  6. Install the cable cover bracket (2) to the seat back pivot assembly.
  7. Install the 2 bolts (1).

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft)

  8. Pull the pad and cover back over the seat frame.
    9. Fig 5: Locating Seat Components
    GM822756Courtesy of GENERAL MOTORS CORP.
  9. Install the pad and cover to seat with J-strips (1).
  10. Install the spring (2) to the seat adjuster rail.
  11. Install the seat back recliner handle.
  12. Install seat in the vehicle. Refer to Seat Replacement - Bucket .
About FixVault