FixVault
Home › GMC › 2004 › Jimmy 2D Utility, Part Time, Standard › Repair and Diagnosis › Transmission › Manual Transmission Clutch System › Repair Instructions › Pilot Bearing Replacement › Removal Procedure

Removal Procedure

    Fig 1: Removing Clutch Pilot Bearing Using J 43276
    GM353275Courtesy of GENERAL MOTORS CORP.
  1. Remove the Flywheel. Refer to Engine Flywheel Replacement in Engine Mechanical 4.3L.
    2. CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
    NOTE: When using the J 43276 Clutch Pilot Bearing Remover, always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench. Do not allow the J 43276-1 tool body to rotate. Failing to do so causes damage to the J 43276-1 tool body.
  2. Remove the clutch pilot bearing using the J 43276  .
    1. Install the J 43276-1 tool body into the clutch pilot bearing.
    2. Using a wrench secure the J 43276-1 tool body.
    3. Insert the J 43276-2 forcing screw into the J 43276-1 tool body.
    4. Rotate the J 43276-2 forcing screw clockwise into the J 43276-1 tool body until the clutch pilot bearing is completely removed from the crankshaft.
    5. Rotate the J 43276-2 forcing screw counterclockwise to remove the J 43276-2 forcing screw from the J 43276-1 tool body.
    6. Remove the J 43276-1 tool body from the clutch pilot bearing.
  3. Discard the clutch pilot bearing.
About FixVault