FixVault
Home › GMC › 2004 › Jimmy 4D Utility, AWD › Repair and Diagnosis › Engine Performance › System › Engine Control System - 4.3L (Introduction) › Repair Instructions › Ignition Control Module Replacement › Removal Procedure

Removal Procedure

    Fig 1: Locating Ignition Control Module Components
    GM690078Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector (3).
  2. Remove 2 screws (4) holding the ignition control module (2) and the heat sink (1) to the bracket.
  3. Remove the ignition control module and heat sink.
About FixVault