FixVault
Home › GMC › 2004 › Sierra 2500, 4D Pickup, 4WD, Part Time › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Brake Pedal Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Brake Pedal Position Sensor
    GM1399584Courtesy of GENERAL MOTORS CORP.
  1. Connect the brake pedal position sensor (2) electrical connector (1).
    2. Fig 2: Aligning Brake Pedal Position Sensor With Actuation Arm
    GM1399586Courtesy of GENERAL MOTORS CORP.
  2. Align the brake pedal position sensor (1) with the actuation arm (2) on the brake pedal and the brake pedal position sensor mounting bracket.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 3: Installing New 4 mm Bolt With LOCTITE™ To Brake Pedal Position Sensor
    GM1399581Courtesy of GENERAL MOTORS CORP.
  3. Install a new 4 mm bolt (1), with LOCTITE™, to the brake pedal position sensor.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  4. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration Description and Operation .
About FixVault