Removal Procedure

IMPORTANT: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

Remove the body side trim panels. Refer to Trim Panel Replacement - Body Side (2-Door Utility) or Trim Panel Replacement - Body Side (4-Door Utility) in Interior Trim.
For the 2-door utility only, remove the anchor bolt securing the rear seat belt assembly to the roof.

CAUTION: Refer to Defroster Outlet Caution in Cautions and Notices.

Cover to protect the following parts from broken glass:
- Upper dash pad
- Defroster outlets and A/C outlets
- Seats and carpeting

CAUTION: Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.

For the 2-door utility only, cut the 2 rivets securing the glass assembly (2-door utility only).

Fig 1: Separating Urethane Adhesive From Window

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Keep the cutting edge of the tool against the window.

This will allow the urethane adhesive to be separated from the window.
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clear water.
- Use J 24402-A , J 39032 or equivalent in order to remove the window. See Special Tools .
With the aid of an assistant, remove the stationary window from the opening.