FixVault
Home › GMC › 2005 › Jimmy Part Time, Standard › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Automatic Transmission - Introduction & Repair Instructions) › Repair Instructions › Floor Shift Control Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Shift Control Assembly
    GM449261Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control assembly to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts securing the shift control assembly to the floor panel.

    Tighten:  Tighten the nuts to 25 N.m (18 lb in).

  3. Install the range selector cable to the shift control assembly. Refer to Automatic Transmission Range Selector Cable Replacement (Column Shift)  or Automatic Transmission Range Selector Cable Replacement (Console Shift) .
    4. Fig 2: View Of Console
    GM303478Courtesy of GENERAL MOTORS CORP.
  4. Install the center console assembly. Refer to Console Replacement - Front Floor (Full Length (Auto Trans)) or Console Replacement - Front Floor (Non-Full Length) or Console Replacement - Front Floor (Full-Length (Manual Trans)) in Instrument Panel, Gages and Console.
  5. Install the shift lever handle and boot. Refer to Floor Shift Control Boot Replacement 
About FixVault