Installation Procedure

Fig 1: View Of Relay Rod At Pitman Arm

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the pitman arm washer and nut to the pitman arm shaft.
Tighten: Tighten the pitman arm shaft nut to 250 N.m (185 lb ft).
Install the relay rod ball stud to the pitman arm.
Ensure the seal is on the stud.
Install the new nut to the relay rod ball stud.
Tighten: Tighten the relay rod ball stud nut to 48 N.m (36 lb ft).
Lower the vehicle.