Installation Procedure

Fig 1: Removing Window Regulator Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts to the window regulator.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
Align the window to the regulator and install the bolts holding the window to the regulator.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
Connect the wiring harness to the window motor assembly.
Install the water deflector. Refer to Water Deflector Replacement - Front Door .
Install the trim panel. Refer to Trim Panel Replacement - Side Front Door .
Lower the window. Inspect the window operation.