Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Ignition Control Module Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Position the ignition control module (2) and heat sink (3).
Install ignition control module (2) screws.
Tighten: Tighten the screws to 3.5 N.m (31 lb in).
Connect the ignition coil driver electrical connector (3).
Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .