FixVault
Home › GMC › 2006 › Sierra 1500 HD, RWD › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Power Steering Pump Bracket Replacement › Installation Procedure

Installation Procedure

  1. Install the power steering pump (3) bracket to the engine.
    Fig 1: Installing Power Steering Pump Bracket
    GM1202281Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the power steering pump bracket retaining bolts.

    Tighten:  Tighten the power steering pump bracket retaining bolts to 25 N.m (18 lb ft).

  3. Install the power steering pump to the bracket. Refer to Power Steering Pump Replacement (4.3L) , Power Steering Pump Replacement (4.8L, 5.3L and 6.0L) , Power Steering Pump Replacement (8.1L) , Power Steering Pump Replacement (6.6L Diesel)  or Power Steering Pump Replacement (5.3L w/RPO HP2) .
  4. Install the positive battery junction block bracket retaining bolts (2) to the power steering pump bracket.
    Fig 2: Installing Positive Battery Junction Block Bracket To Pump Bracket
    GM1237043Courtesy of GENERAL MOTORS CORP.

    Tighten:  Tighten the battery junction block retaining bolts to 9 N.m (80 lb in).

About FixVault