Installation Procedure
WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- Install the accelerator pedal cable (5) to the motor.
- Synchronize the pedals to the full forward position.
- Synchronize the brake pedal to the full forward position. Use the instrument panel switch, the Tech II, or manually move the brake pedal as follows:
- Use an adjustable wrench on the accelerator pedal end of the accelerator pedal cable.
- Slowly rotate the accelerator cable to move the brake pedal to the full forward, front of vehicle position.
- Remove the wrench from the vehicle.
- Synchronize the accelerator pedal to the full forward position. Proceed as follows before pedal installation:
- Install a square drive tool into the accelerator pedal where the cable attaches.
- Carefully rotate the tool to move the adjustable pedal to the full forward position.
- Remove the square drive tool.
- Connect the adjustable accelerator pedal cable to the pedal assembly.
- Ensure that the adjustable accelerator pedal cable retaining feature is locked in place by carefully pulling on the cable.
- Continue the installation procedure for the accelerator pedal assembly. Refer to Accelerator Pedal Assembly Replacement (LHD) or Accelerator Pedal Assembly Replacement (RHD) .
- Perform the adjustable pedal calibration procedure. Refer to Adjustable Pedal System Calibration .
IMPORTANT:
Ensure that the adjustable accelerator pedal and adjustable brake pedal are synchronized in the full forward, front of vehicle position.
IMPORTANT:
During the synchronization procedure, do not exceed 0.5N.m (4.43 lb in) of torque while adjusting the pedals with the use of the cable, or the square drive.