FixVault
Home › GMC › 2007 › Acadia SLT, AWD › Repair and Diagnosis › External Pages › Different car › Section 280 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Side Impact Module Replacement - Front › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Inflator Module Handling and Storage Caution .
    CAUTION: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:
    • The seat cushion frame
    • The seat recliner, if equipped
    • The seat adjuster
    • The seat back frame

    Failure to do so may cause future personal injury.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
    2. IMPORTANT: Removal of the right or the left inflatable restraint side impact module uses the same procedure.
  2. Move the seat to the full forward position.
  3. Remove the seat back panel cover (2) from the seat (1) by pulling out the bottom of the panel and lowering the top away from the seat to release the hook retainers.
    4. Fig 1: Locating Inflatable Restraint Side Impact Module Bracket Bolts
    GM792279Courtesy of GENERAL MOTORS CORP.
  4. Remove the 2 bolts (1) from the inflatable restraint side impact module bracket.
  5. Remove the module from the seat.
  6. Remove the connector position assurance (CPA) from the module electrical connector.
    7. Fig 2: View Of Inflatable Restraint Side Impact Module Electrical Connector
    GM792283Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the electrical connector (1) from the module.
About FixVault