Installation Procedure
WARNING: This page is about a different car, the 2007 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove any dirt, grease, or other impurities from the mounting surface.
- Install the SIS (1) to the center pillar.
- Install the SIS mounting fasteners (2).
Tighten: Tighten the fasteners to 9 N.m (80 lb in).
- Install the harness connector (2) to the SIS (3).
- Install the CPA (1) to the SIS harness connector (2).
- Install the center pillar trim. Refer to Center Pillar Garnish Molding Replacement .
- Move the seat to the original position.
- Enable the SIR system. Refer to SIR Disabling and Enabling .
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.