ECM Replacement

If the engine control module (ECM) is replaced, the following procedures must be performed:

IMPORTANT: The option data must be captured before powering down the ECM, and must be restored before performing the ECM reprogramming procedure.
• Capture and restore the Option data.
IMPORTANT: DTC P0606 may set during SPS Programming. Clear the DTC after completing these procedures.
• The ECM Reprogramming-Refer to Service Programming System (SPS) .
• The Turbocharger Learn Procedure-Refer to Turbocharger Learn .
• Theft Deterrent-Refer to Programming Theft Deterrent System Components .
• The Fuel Injector Flow Rate Programming-Refer to Fuel Injector Flow Rate Programming .
• Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was reprogrammed.
• Transmission Fluid Life Remaining-When available, use a scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was reprogrammed.
• Fuel Filter Life Remaining-When available, use a scan tool to reset the Fuel Filter Life Remaining back to the original percentage recorded before the module was reprogrammed.