FixVault
Home › GMC › 2008 › Yukon Base, 4.8 C › Repair and Diagnosis › External Pages › Different variant/trim › Section 4 (Hybrid Engine Control System) › Diagnostic Information and Procedures › DTC P2797 › Circuit/System Testing › Notes

Circuit/System Testing: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Inspect for DTC P0C2B. Diagnose P0C2B before performing this procedure.
  2. Ignition ON, engine OFF, observe the Aux. Trans. Fluid Pump Fault Status 1 and Aux. Trans. Fluid Fault Status 2 displays with the scan tool.
  3. Command the aux. trans. fluid pump speed to 50 percent with the scan tool.
    • Refer to the applicable diagnostic procedure below for the fault status indicated by the scan tool display.
    • If No Fault status is displayed, review the Freeze Frame/Failure Records and perform the diagnosis indicated by the Fault Status parameter display.
About FixVault