FixVault
Home › GMC › 2011 › Canyon 4D Pickup, 2.9 9 › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 2.9L - Repair Instructions › Repair Instructions › Engine Control Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of ECM
    GM1352004Courtesy of GENERAL MOTORS CORP.
  1. Install the ECM into the ECM mounting bracket, allowing the tabs to fully engage.
    2. Fig 2: View Of ECM/PCM & ECM/PCM Harness Connectors
    GM1350711Courtesy of GENERAL MOTORS CORP.
  2. Connect the ECM harness connectors (2) to the ECM body (3).
  3. If a new ECM is being installed, the ECM must be programmed. Refer to Control Module References .
  4. If equipped with a manual transmission, perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn .
About FixVault