FixVault
Home › GMC › 2011 › Canyon 4D Pickup, 5.3 P, 4WD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 5.3L - Repair Instructions › Repair Instructions › Knock Sensor 1 Replacement › Installation Procedure

Installation Procedure

    Fig 1: Locating Knock Sensor 1
    GM1352025Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the KS (2) and the retaining bolt to the engine block, positioning the electrical terminals down.

    Tighten:  Tighten the KS bolt to 25 N.m (18 lb ft).

  2. Connect the engine wiring harness electrical connector to the KS (2).
  3. Lower the vehicle.
About FixVault