FixVault
Home › GMC › 2012 › Yukon Base, 4WD › Repair and Diagnosis › External Pages › Different variant/trim › Section 5 (Hybrid/EV Control System) › Diagnostic Information and Procedures › DTC P2534 › Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the T6 drive motor generator power inverter module connector X1.
  2. Ignition ON, measure the voltage on the ignition 1 circuit, between connector X1 terminal 20 and ground. The voltage should be within 1.0 V of the battery voltage.
    • If not the specified value test the ignition 1 signal circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the T6 drive motor generator power inverter module.
About FixVault