Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Terrain and 2010 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Place the ignition switch in the OFF position.
Remove the accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement .

Fig 1: BPMV Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the brake pressure modulator valve (BPMV) bolt (1).

Fig 2: BPMV Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Do not pry on the accumulator caps on the underside of the BPMV.

Without disconnecting the brake pipe fittings, carefully lift the BPMV assembly (1) upward to release the mounting pins from the BPMV bracket insulators.
Position the BPMV assembly aside and secure with heavy mechanics wire or equivalent.

Fig 3: BPMV Bracket Nuts

Courtesy of GENERAL MOTORS CORP.

Remove the 2 BPMV bracket nuts (1).

Fig 4: BPMV Bracket Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the BPMV bracket bolt (1).

Fig 5: BPMV Bracket

Courtesy of GENERAL MOTORS CORP.

Remove the BPMV bracket (1).
Inspect the insulators for damage and replace, if necessary.