FixVault
Home › GMC › 2017 › Acadia SL › Repair and Diagnosis › Suspension › Electronic Suspension › Suspension Control System › Repair Instructions › Electronic Suspension Control Module Replacement › Installation Procedure

Installation Procedure

  1. Connect Electrical Connector @ Electronic Suspension Control Module
    2. Fig 1: Electronic Suspension Control Module And Bracket
    GM4311128Courtesy of GENERAL MOTORS COMPANY
  2. Install the electronic suspension control module (1) until it is fully seated into the electronic suspension control module bracket (2) and secured by the tab as indicated.
    3. Fig 2: Electronic Suspension Control Module And Bracket Nuts
    GM4311115Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install Electronic Suspension Control Module (2)
  4. Install and tighten Electronic Suspension Control Module Bracket Nuts (1) (Qty: 3) to 9 N.m (80 lb in)
  5. Install the acoustic treatment.
  6. Install the spare tire.
  7. Install the load floor trim panel. Refer to Load Floor Trim Panel Replacement (All Terrain)
  8. Program the electronic suspension control module. Refer to Control Module References
About FixVault