Circuit/System Verification

DTC C0460 4B

1. Ignition ON.
2. Verify that DTC C0460 4b is not set.
   • If the DTC C0460 4B is set 

     Perform Steering Wheel Angle Sensor Centering with scan tool.

   1. Verify that DTC C0460 4B is not set.
      • If the DTC C0460 4B is set 

        Replace the electronic power steering motor control module.

      • Go to next step: If the DTC C0460 4B did not set 

        Go to next step: All OK.

   • Go to next step: If the DTC C0460 4B is not set 
3. All OK.

DTC C0460 58

1. Ignition ON.
2. Verify that DTC C0460 58 is not set.
   • If the DTC C0460 58 is set 

     Replace the Electric Belt Drive Rack and Pinion Steering Gear.

   • Go to next step: If the DTC C0460 58 is not set 
3. All OK.

DTC C0460 5A

1. Ignition ON.
2. Verify that DTC C0460 5A is not set.
   • If the DTC C0460 5A is set 

     Perform Steering Wheel Angle Sensor Centering with scan tool.

   1. Verify that DTC C0460 5A is not set.
      • If the DTC C0460 5A is set 

        Replace the electronic power steering motor control module.

      • Go to next step: If the DTC C0460 5A did not set 

        Go to next step: All OK.

   2. Verify that DTC C0460 58 did not reset.
      • If the DTC C0460 58 is set 

        Replace the Electric Belt Drive Rack and Pinion Steering Gear.

      • Go to next step: If the DTC C0460 58 did not set 

        Go to next step: All OK.

   • Go to next step: If the DTC C0460 5A is not set 
3. All OK.