Programming an Existing or New Control Module
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Sierra 3500 HD, 2018 GMC Sierra 2500 HD, 2018 GMC Sierra 1500, 2018 Chevrolet Silverado 3500 HD, and 2018 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
To program an existing or new control module, perform the following procedure:
- Install the special tool: EL-49642 SPS Programming Support Tool
- Ignition - On/Vehicle - In Service Mode
- Access SPS and follow the on-screen instructions for the control module: K71 Transmission Control Module - Programming
- After programming is complete, select: MCVM Operations from the Select Function/Sequence Menu (if available) - For more information refer to:Q77 Transmission Control Solenoid Valve Characterization Programming
- After the above step is complete, select: Setup - follow the on screen instructions.
- Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.
- All OK.