FixVault
Home › GMC › 2019 › Terrain SL › Repair and Diagnosis › External Pages › Different car › Section 105 (Rear Drive Axle) › Repair Instructions › Rear Differential Clutch Control Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 GMC Terrain and 2018 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Clutch Control Module
    GM5045270Courtesy of GENERAL MOTORS COMPANY
  1. Position the clutch control module (1) onto the rear axle.
    2. Fig 2: Connectors And Control Module
    GM5045268Courtesy of GENERAL MOTORS COMPANY
  2. Reconnect the electrical connectors to the clutch control module.
    3. Fig 3: Control Module Brackets
    GM5045267Courtesy of GENERAL MOTORS COMPANY
  3. Install the control module brackets (1).
    4. Fig 4: Four Control Module Bolts
    GM5045265Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    NOTE:

    Apply loctite before installing bolts.

  4. Install the clutch control module bolts (1). Tighten to 10 N.m (89 lb in).
    5. Fig 5: Control Module Bracket Bolts
    GM5045263Courtesy of GENERAL MOTORS COMPANY
  5. Install the control module bracket bolts (1). Tighten to 10 N.m (89 lb in).
    6. Fig 6: Control Module Bracket Bolt
    GM5045261Courtesy of GENERAL MOTORS COMPANY
  6. Install the control module bracket bolt (1). Tighten to 10 N.m (89 lb in).
  7. Remove the support and lower the vehicle.
  8. Reprogram the K47 Rear Differential Clutch Control Module. Control Module References
About FixVault