FixVault
Home › GMC › 2019 › Terrain SL › Repair and Diagnosis › External Pages › Different car › Section 105 (Rear Drive Axle) › Repair Instructions › Rear Differential Clutch Control Module Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 GMC Terrain and 2018 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the control module for removal using the SPS programming support tool. K47 Rear Differential Clutch Control Module: Programming and Setup
    2. NOTE:

    The rear differential clutch control module can now be removed and replaced.

  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
    3. Fig 1: Control Module Bracket Bolt
    GM5045261Courtesy of GENERAL MOTORS COMPANY
  3. Remove the control module bracket bolt (1).
    4. Fig 2: Control Module Bracket Bolts
    GM5045263Courtesy of GENERAL MOTORS COMPANY
  4. Remove the control module bracket bolts (1).
    5. Fig 3: Four Control Module Bolts
    GM5045265Courtesy of GENERAL MOTORS COMPANY
  5. Remove the four control module bolts (1).
    6. Fig 4: Control Module Brackets
    GM5045267Courtesy of GENERAL MOTORS COMPANY
  6. Remove the control module brackets (1).
    7. Fig 5: Connectors And Control Module
    GM5045268Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect the connectors from the control module.
  8. Remove Wiring Harness Retainer from Clutch Control Module.
    9. Fig 6: Clutch Control Module
    GM5045270Courtesy of GENERAL MOTORS COMPANY
  9. Remove the clutch control module (1) by rotating it 180 degrees and sliding it out of the passenger side area above the axle shaft.
About FixVault