Installation Procedure
Install the electronic power steering motor control module bracket (2).
- Prepare the 2 electronic power steering motor control module bracket bolts (1) for installation as follows:
- Remove all traces of the adhesive patch from the bolts and the mating threads using the appropriate tools.
- Clean the threads of the bolts and mating threads with denatured alcohol or equivalent and allow to dry.
- Apply thread locking adhesive to the bolts. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the thread locking adhesive once applied to the bolt.
- Install the 2 electronic power steering motor control module bracket bolts (1) and tighten to 6 N.m (53 lb in).
Install the electronic power steering motor control module (3).
- Install the electronic power steering motor control module bracket bolt (2).
- Install the electronic power steering motor control module bracket nut (1) and tighten to 25 N.m (18 lb ft).
- Install the left front wheelhouse liner. Front Wheelhouse Liner Replacement
Install the electronic power steering motor control module bracket bolt (2) and tighten to 15 N.m (11 lb ft).
- Connect the electrical connectors (1).
- Underbody Skid Shield - Install - Underbody Skid Shield Replacement
- Perform the steering wheel angle center sensor centering procedure. Steering Wheel Angle Sensor Centering
- Perform the necessary programming and setup procedures: Control Module References
CAUTION:
Refer to Fastener Caution .
CAUTION:
The electronic power steering motor control module and bracket are held together by fasteners that thread into brass inserts embedded in the control module housing. Do NOT overtighten the fasteners or the brass inserts will break free from the housing resulting in unnecessary replacement of the control module.