Installation Procedure

WARNING: This page is about a different car, the 2020 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Position the clutch control module (1) onto the rear axle.
Courtesy of GENERAL MOTORS COMPANY

Reconnect the electrical connector (1 and 2) to the clutch control module.
Install Wiring Harness Retainer to the Clutch Control Module.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Install the clutch control module bracket bolts (1). Tighten to 6 N.m (53 lb in).
Install the differential carrier assembly. Differential Carrier Assembly Replacement
Remove the support and lower the vehicle.
Reprogram the K47 clutch control module. Control Module References