Fastener Specifications
WARNING: This page is about a different car, the 2021 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Front Bolt | |
|
100 N.m (74 lb-ft) |
|
90 - 105 degrees |
| Front Lower Control Arm Rear Bolt | |
|
100 N.m (74 lb-ft) |
|
90 - 105 degrees |
| Front Stabilizer Shaft Insulator Clamp Bolt | |
|
30 N.m (22 lb-ft) |
|
90 - 105 degrees |
| Front Wheel Bearing and Hub Assembly Bolt | |
|
100 N.m (74 lb-ft) |
|
65 - 75 degrees |
| Steering Knuckle Bolt | Torque mating fastener |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Ball Stud Nut | |
|
40 N.m (30 lb-ft) |
|
100 - 115 degrees |
| Front Stabilizer Shaft Link Nut | 100 N.m (74 lb-ft) |
| Front Strut Rod Mount Nut | 70 N.m (52 lb-ft) |
| Front Suspension Strut Bolt | 22 N.m (16 lb-ft) |
| Steering Knuckle Nut | |
|
100 N.m (74 lb-ft) |
|
45 - 60 degrees |